Variable Repeat Sleeve
The Variable Repeat Sleeve; This sleeve size is determined by the size of the mandrel on your press, the repeat you require to print and the thickness of your mounting tape and repro plate. They range from 2.5mm in thickness up to 75mm. The inner diameter of this sleeve can be from as little as 70.140mm up to as much as 308.627mm. These are all based on the Stork international sizes. All these sleeves come with two scribe lines for mounting purposes, standard locator slots (unless otherwise specified) and an easily identifiable label in the sleeve.
Product advantages
- Low weight, high strength of layers
- Compatible with all mounting tapes
- Anti-static surface use at a nominal cost.
- Easy to handle
- Encapsulated inner core no delaminating
- Can be used on adapters
- Sleeves can be recoated after extensive
Product features
- Hard sleeve surface compatible with all tape and plate combinations.
- Repeats from 240mm and up.
- Robust sleeve design made of glass composites.
- Easily cleaned and solvent resistant surface.
- Stainless steel locating slot on 3mm and thicker sleeves for improved locating.
- Sleeve is not prone to indents caused by accidental damage.
Typical Sleeve Data:
- Max T.I.R 0.04mm
- Max Taper 0.04mm
- Max Length deviation 2mm
- Static Dispersion <1 Mega Ohm
- Min Wall 0.8mm
- Max Wall 75mm
- Not affected by humidity
- Cleaning with non aggressive solvents
- Scribes as per requirement